debug phy-err-injection

This command debugs the Rx physical error injection.

Syntax

# debug phy-err-injection 

Command	Description
set delay-depth <Value>	Configures the delay depth, in packets
set delay-rate <Value>	Configures the delay rate
set drop-rate <Value>	Configures the drop rate
set interface {atm|efm|fiber|gigabitethernet}	Configures the interface to run the Rx error on: ■ atm <Group/Subinterface> ■ efm <Slot/Port.vlanID> ■ fiber <Slot/Port> ■ gigabitethernet <Slot/Port.vlanID> Example: 0/0.150 where slot=0, port=0 and vlanID=150
show	Shows the configuration of the Rx physical error injection.
start	Starts the Rx physical error injection.
stop	Stops the Rx physical error injection.

Command Mode

Privileged User

Example

This example starts debugging the RX physical error injection on the Gigabit Ethernet interface, slot 0, port 0 and VLAN ID 150:

# debug phy-err-injection set interface gigabitethernet 0/0.150